Reloop BEATPAD - VirtualDJ 8 Operation Guide User Manual download pdf (Page 11)

VirtualDJ 8 – Reloop Beatpad

Sampler mode

Press the SAMPLER mode button to set the PADs to Sampler mode.

Each one of the pads triggers a sample from

the selected Sampler Bank of VirtualDJ. If a

bank has less than 5 samples, both sides of

the Beatpad will control the same samples. If a

bank has more than 4 samples, the left side of

the Beatpad will control samples 1 to 4 and

the right side samples 5 to 8.

The LEDs of the Pads will tend to get the

assigned color of each sample, however the

colors may not match perfectly due to the

limited offered colors of the Pads.

Press the pads to trigger a sample.

Depending on the selected trigger mode, use

SHIFT and the same pads to stop the

sample.

If the SAMPLER mode is selected, press and

hold down the same Mode button to receive

the Sampler parameters.

Use Pads 1 and 2 to select the previous and

next available Sampler Bank.

Use Pads 3 and 4 to select the next sampler

trigger mode (On/off, Hold, Stutter and

Unmute)

F. FRONT

32. MIC INPUT. Connect a 1/4" microphone to this input. This input's audio signal is

routed directly to the Program Mix and Cue Mix.

33. MIC LEVEL. Adjust the gain of the microphone input channel.

34. HEADPHONES SOCKET. Connect your 1/4" headphones to this output for cueing

and mix monitoring.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Reloop BEATPAD - VirtualDJ 8 Operation Guide User Manual Page 11